Home > Event Id > Event Id 11 Adpu160m

Event Id 11 Adpu160m

Contents

Yes: My problem was resolved. If the SCSI Controller does not have the system boot device attached, disable the BIOS. After attaching a SCSI device it is not detected by the card's BIOS. Otherwise, this error is usually due to poor cabling, loose cables, a failing controller, or failing hardware, such as the Primary IDE controller for your hard drive". Check This Out

Verify that your system has at least the minimum amount of memory required by your operating system. [xxxxx0af] Unable to de-allocate memory that was allocated for a target device Normally, this Copyright © 2004-2016 Fixwindowserror.org. One of them I was able to find the cause by simply installing Dell OpenManager Server Administrator and taking a look at the storage.The firmware driver was out of date. x 353 Anonymous I got this error after buying a new power supply.

Event Id 11 Disk Controller Error

Scatter/Gather is a means to improve total data throughput. They both have scsi terminal enabled in scsi bios, scsi bus reset disabled. I then removed the "Remote Storage Service".

Some updates will not installed Runtime Error XXX, Paste method of worksheet failed. If you boot from a SCSI device attached with the SCSI controller, leave the SCSI Controller Int 13 Support" at "Enabled". See MSW2KDB for more details on this event. Event Id 15 Disk Not Ready For Access x 45 Deej In n order to solve this problem I downloaded the free "HP StorageWorks Library and Tape Tools".

From a newsgroup post: "I had the same error on my MSI board, 1700 AMD XP, 512mb Ram, 2 hard drives each partitioned at 20x20, and Windows 2000 Advanced Server. Event Id 11 Disk The Driver Detected A Controller Error See ME895573 to get the hotfix. So, using the program, I downloaded the latest version and did what it said. This event ID was accompanied by EventID 9 Source adpu160m, EventID 117 from source adpu160m, and EventID 10026 from source DCOM.

Try installing the most up-to-date version of the driver available from the Adaptec Web site. Event Id 11 Atapi After a while the D: drive failed. This event is logged in configurations where a DASD (Direct Access Storage Device [hard disk]) or a RAID array consisting of multiple DASD devices attached to an Adaptec controller is used x 136 EventID.Net As per Microsoft: "ATA66 DMA transfer mode is not supported for the onboard IDE controller." See the link below.

Event Id 11 Disk The Driver Detected A Controller Error

See example of private comment Links: EventID 11 from source Disk Search: Google - Bing - Microsoft - Yahoo - EventID.Net Queue (0) - More links... http://kb.eventtracker.com/evtpass/evtPages/EventId_11_adpu160m_47128.asp Related Products: SCSI Adapters SCSI HBAs - Ultra320 Family Adaptec SCSI Card 29320LPE Adaptec SCSI Card 29320A-R Adaptec SCSI Card 29320ALP-R Adaptec SCSI Card 39320A-R Event Id 11 Disk Controller Error Press Esc again, exit the utility and reboot the system. Event Id 11 Windows 7 Event Id 11 Adpu160m problem seems as a petential risk for your PC.

They said this is a symptom of a known driver problem for the HP ProLiant 64-Bit66-Mhz Dual Channel Wide Ultra3 SCIS Controller. http://radionasim.com/event-id/event-id-7022-system-event.php Answer ID 15055 | Published 03/19/2007 02:07 PM | Updated 03/11/2014 12:51 AM The Windows System Log shows the following error messages: Event ID: 9 Source: drivername Description: The device, \Device\ScsiPortx, x 47 Ricky Wilson I find that if I get a cyclic redundancy check (which 90% of the time turns out to be a bad SDLT tape), this error occurs. TheEventId.Net for Splunk Add-onassumes thatSplunkis collecting information from Windows servers and workstation via the Splunk Universal Forwarder. Event Id 11 The Driver Detected A Controller Error On Device Harddisk1 Dr1

Comments: Sf4000 We had it due to failing battery on PERC 6/i. Error messages generated by the driver show up as Event ID 11. x 49 Private comment: Subscribers only. http://radionasim.com/event-id/event-viewer-error-wmi-event-id-10.php Normally this is not a serious problem.

DriverTuner is an easy-to-use driver update software for you to install outdaged drivers in 3 steps! Event Id 11 Wininit x 315 Alexander Freudenberg In certain conditions, this error message is related to the S.M.A.R.T attribute 187 (Reported uncorrectable errors). See Microsoft Knowledgebase Article Q154690 for more information.

Login here!

x 51 Peter Hayden In one case, a computer was running Windows 2003 that had an Adaptec Ultra 160 (19160) SCSI Adapter that was being used to control separate C: and Keeping an eye on these servers is a tedious, time-consuming process. x 275 Corey Monteiro Boot-up was also very slow when these errors began to occur. Event Id 11 Custom Dynamic Link Libraries You might have to contact the vendor of the device for technical support, or you might have to replace the controller.

All Rights Reserved. Thanks a lot! x 49 Bob Laidman I called HP support on this one, as we were seeing blue screens when ever a bad tape was discovered in our tape library. navigate here x 314 Anonymous I had this problem with a new computer.

Yes: My problem was resolved. Email *Required Your Feedback *Required Answers others found helpful How to troubleshoot Event ID 51 warning message in Windows? x 233 Anonymous I've had three of these errors pop up on our Level Platforms alerts. Mais après l'installation de cet outil, je reçois rarement pop up erreur.

Je ne sais pas si elle est vraiment utile. Normally, this indicates a faulty or non-compliant target device. [xxxxx022] Adapter or target device protocol error The adapter or target device has broken the communication protocol.